Electromagnetic Flow Meter Supporting Diameter DN25-2600mm for Industrial Liquid Monitoring

Description

LD Series electromagnetic meter is a kind of electromagnetic induction type flow meter, which consists of  sensor and intelligent signal conversion. it can measure the volume flow rate of all kinds of conducting liquids including acid, alkali, salt and strong corrosive liquids and pulp, mud, oars, sewage water and liquid with solid. It is mainly applicable to petrochemical, steel, electricity, metallurgy, textiles, food, paper and pharmaceutical industries and the environmental protection and water conservancy projects and other fields.

Technical Specification

Suitable tube caliber: DN25~DN2600(below DN25 unstandard)  

Electrode material: 316L(stainless steel), HC, HB, Ti, Ta  

Suitable Medium: Liquid with conductive ratio more than 5 μs/cm  

Measuring range: 0.1~10m/s (extendable to 15m/s)

Upper limit of span: 0.5~10m/s. 1~5m/s recommended  

Accuracy class: 0.3, 0.5, 1.0  

Output signal: 4~20mADC, load≤ 750Ω, 0~3kHz, 5V with source and changeable width. High terminal and effective frequency output, RS485 interface

Operation pressure: 1.0MPa, 1.6MPa, 4.0MPa, 16MPa (special)  

Fluid temperature: 20C~80C, 80C~130C, 130C~180C according to liner material  

Environmental temperature:  sensor40~80º C. Transducer 15~50º C  

Environmental humidity: ≤85%RH (at 20º C)  

Cable outlet size: M20x1.5  

Power supply: 220VAC± 10%, 50Hz± 1Hz, 24VDC± 10%  

Power consumption: ≤8W  

Protection ratings  Combined type: IP65. Separate type: Sensor IP68, transducer IP65  

Materials of liner: PTFE, soft rubber etc  

Connection of flange: GB911988(DIN2051, BS4504)  

Earthing material: 1Cr18Ni9Ti (stainless steel), HC, Ti, Ta, Cu

Flow Range